Enviro Bio Cleaner - RESTORER - 1GAL
Enviro Bio Cleaner - RESTORER - 1GAL
Revolutionary new product replaces traditional hazardous acid cleaners!
EBC Restorer formula works with excellent health and safety benefits. A low pH combination of selected chemical cleaners and a perfectly blended amount of soaps makes this a truly unique product for cleaning and restoring hard surfaces. Used for the removal of tire marks, restoring and revitalizing concrete, surface rust stains, mineral deposits. EBC Restorer replaces hydrochloric, citrus, glycolic, phosporic, nitric and other DOT hazardous acids - A low pH organic salt combined with a specific blend of cleaning agents that performs superbly in many cleaning and restoration projects.
Organic salt that acts like an acid; pH & pKa of less than 1.0 Acid stable blend of cleaning agents More effective than Citric Acid, Glycolic Acid and even Phosphoric Acid when dissolving calcium carbonate Performance, cost and safety advantages verses acids such as Phosphoric, Citric, Hydroxyacetic, Sulfmaic, Oxalic. DOT Classification: Non-Regulated Non-Fuming Phosphate FREE & contains no VOC's NON- HAZMAT
--NO HAZMAT SHIPPING ON 1'S, 5'S, OR 55 GAL DRUM--
General Use:
For light cleaning/restoration 1:20
For moderate cleaning/restoration 1:10
For heavy cleaning/restoration 1:5
For mildly soiled/dirty concrete, apply a dilution of between 10:1 – 20:1 of EnviroBioCleaner Restorer with water either by downstream of pump up sprayer. Pre mist surface before application for best result. Surface clean area rinse well to neutralize pH level to acceptable level.
For heavy oil/grease spots on concrete – pretreat with EBC Multipurpose Cleaner/Degreaser or your degreaser of choice. EnviroBioCleaner Restorer can be applied around oil/grease areas to allow maximum penetration and dwell time for oil lifting process without 2 stepping the cleaning area. **Do NOT introduce or add Sodium Hypochlorite (BLEACH) to process.**
Tire Marks – For light to medium tire marks on concrete or similar surfaces, apply a dilution of 10:1 – 15:1 with water of EnvirBioCleaner Restorer directly onto the surface and immediately clean/rinse off with pressure washer wand or surface cleaner. Do dwell time required.
For Heavy tire marks on concrete or similar surfaces, apply a dilution of 5:1 – 8:1 with water of EnviroBioCleaner Restorer directly on the surface and immediately clean/rinse off with pressure washer wand or surface cleaner. Repeat process if deep tire burns are still evident.
Light Rust Removal – For light and surface rust removal, apply up to a dilution of 1:1 of EnviroBioCleaner Restorer with water. Apply directly to surface. Prewet area first for rust removal application due to ratio strength. Product will dissolve the rust slowly. For vertical surface rust will dissolve the rust from top down without corrosive fumes. Agitation may be required for heavy stains. Rinse area with pressure washer.
Other Applications:
Tub & Tile Cleaner – Urinal Cleaner – Grout Cleaner Bowl Cleaner, Descalers – Acid Presoaks, Concrete Truck & Equipment Cleaner. Post cleaning/concrete restorer on heavy oil/food grease areas.
Surfaces:
Ceramic Toilets, Concrete, Decorative Concrete, Pavers, Plastic Urinals, Porcelain Shower Rooms – Stainless Steel
Other Uses:
Acid truck wash – Tarnish remover – AC and Cooling Coil Cleaner – Milk Stone Remover – Kennel Cleaner – Steam table cleaner – Memorial Stone cleaner.
Related Categories
No videos to display at this time.